This was an Experiment of mine to see If I could
make a Para Cord Flogger....Ladies Style
Step By Step Instructions To Make a Para Cord Flogger
by Brian Schill
Materials needed :
27 feet of para cord ( color of your choice)
( a little more is OK too.)
Tools needed :
Scissors
Small Crewdriver
Tape Measure
Loosely loop the para cord over a 24 inch
span six (6) times
leave a short tail on one side
and the remaining para cord
on the other side as shown.
Tighten and even up the loops by pulling
a finger through each end and pulling
until they are even out as shown.
Leave a short tail over as shown as
leaving the longer remaining para
cord hanging.
The short piece will form the
hanger loop.
Take the longer piece of Para Cord and
cross it over the main loops just above
the end of the hanger loop.
Wrap the longer piece of Para Cord
around the main loops as shown.
Continuing to wrap the remaining Para Cord
around the main loops, pulling it tight as you
go, working your way down the main loops
shown in the photo on the left.
As you end near the of the main loops you
should leave a little open at the end of the
handle, as shown, so you can secure the
final wraps of Para Cord.
Take the screwdriver and align all of
the loops so that you can weave the
remaining Para Cord through it.
Take the remaining Para Cord and pass
it through the end loops. I use the screw
driver to assist the para cord through the
loops at this stage.
Pass the remaining para cord through
one side, then wrap around and pass
through the other side.
You should complete the pass through
4-5 times and the end result should
look similar to this.
Make a knot on your final pass
through and cut off the excess.
Lay your flogger out and straighten
out the loops as shown.
Cut the ends of the loops as shown.
It is not important that they are even
We will take care of that momentarily.
.
Tie off the ends of the flogger with a
basic knot so that it doesn't fray.
I try to keep my knots at a uniform
length on the flogger tails, but you
may or may not choose to do this as
it doesn't affect the operation of the
flogger at all.
Once your knots are tied,
trim the excess para cord off.
Your flogger is complete
and
ready to use.
Enjoy !!!
This is the Para Cord Flogger
that I created and followed
the instructions.....
Definitely if I as submissive can make
a para cord flogger, by more colorful
than just plain color, anyone can make
one. Now it is time to have some fun
on my own. And could punish myself
with it too......if I choose.. Enjoy 💋
The next try to a new flogger will be made out of soft leather.
Now only to learn to make a whip....Te hehehehe
👌👌👌👌👌👌👌👌👌👌👌👌👌👌👌👌👌👌👌👌👌👌👌👌👌👌👌👌👌👌👌👌👌👌👌👌👌👌👌👌👌👌
Thank you Brian Schill
💋💋💋
No comments:
Post a Comment